The Taper Deformer.
Here is how the Taper Deformer is set up:
Easy right? Just put it right underneath your object in the hierarchy.
Size – Changes the size of the Deformer.
Strength – How far the Deformer is bent.
Curvature – Changes the curvature of the bulge.
Fillet – When checked it will ease the bulge near the top and bottom
Mode – There are three modes that you can pick from – Limited, Within Box, Unlimited.
- Limited – Everything inside of the Deformer is bent and everything outside of the deformer is moved to stay with the object.
- Within Box – Everything inside of the Deformer is bent but everything outside of the deformer stays exactly where it was
- Unlimited – Everything inside and outside of the deformer is bent